Loading ...
Loading ...
Loading ...
Assembly Instructions
Connect the Handlebar (1) to
the Main Frame (21) using
2 x M8 x 25mm Allen Bolt (7),
2 x M8 Spring Washer (8) and
2 x M8 Curved Washer (59).
ATTENTION!
The Sensor Wire (57) is a
single-wire and the Pulse Wire
(13) is a double-wire. Please
connect these wires to the
wires from the back of the
console(5) as shown in the
diagram.
Attach the Console Holder (6)
onto the Handlebar (1) and
insert the Console (5) onto the
Console Holder (6). Adjust the
angle of the Console(5) as your
desired and fix the Console
Holder with Screw (11).
Step 3
The 3 x M8 Nut (17) and 3 x
Saddle Washer (16) are
pre-assembled on the Saddle
(10).
Remove them before the
assembly of the Saddle (10)
to the Seat post (15).
Fix the Saddle (10) to the Seat
post (15) by re-fitting the 3 x
Saddle Washer (16) and 3 x M8
Nut (17) previously removed.
Attach the Back Rest (80) to the
Seat post (15) by fitting the 2 x
Curved Washer(16) and 2 x M8
Dome Nut(17)
Insert the Seat Post (15) into the
Main frame (21). Position the Seat
Post (15) upward and downward at
your required and secure with the
Lock knob (22).
Note: The seat height is correct
when the knee is slightly angled
with the pedal vertically down and
the foot parallel to the floor.
Step 2
57
7 7
80
8
5
6
5
57
59
Loading ...
Loading ...
Loading ...