Loading ...
Loading ...
Loading ...
12
2. Setting up the monitor
MultiView in OSD menu
• PIP / PBP Mode: There are two
modes for MultiView: [PIP] and
[PBP].
[
PIP
]
:
Picture in Picture
Open up a sub-window of
another signal source.
B
A (main)
When the sub source is
not detected:
B
A (main)
[
PBP
]
:
Picture by Picture
Open up a sub-window
side-by-side of another
signal source.
A (main) B
When the sub source is
not detected:
A (main) B
Note
The black strip shows on the top and
the bottom of the screen for the correct
aspect ratio when in the PBP mode. If
you expect to see full screen side by
side, adjust your devices resolutions as
pop up attention resolution, you will
able to see 2 devices source screen
project to this display side by side
without black strips. Note the analog
signal is not support this full screen in
PBP mode.
• PIP / PBP Input: There are four
different video input to choose as
the sub display source: [VGA], [MHL-
HDMI], [DisplayPort], and [Mini DP].
Please refer below table for compatibility
of main/sub input source.
SUB SOURCE
POSSIBILITY (xl)
Inputs VGA
MHL-
HDMI
Display
Port
Mini
DP
MAIN
SOURCE
(xl)
VGA ● ● ● ●
MHL-HDMI ● ● ● ●
DisplayPort ● ● ● ●
Mini DP ● ● ● ●
• PIP Size: When PIP is activated, there
are three sub-window sizes to
choose: [Small], [Middle], [Large].
B
A (main)
Small
Middle
Large
• PIP Position: When PIP is activated,
there are four sub-window
positions to choose.
Top-Left Top-Right
B
A (main)
B
A (main)
Bottom-Left Bottom-Right
B
A
(main)
A (main)
B
• Swap: The main picture source
and the sub picture source
swapped on the display.
Swap A and B source in [
PIP
] mode:
B
A (main)
↔
B (main)
A
Loading ...
Loading ...
Loading ...