Loading ...
Loading ...
Loading ...
EN
10
5 - Electrical Connections
DANGER
Disconnect power before servicing the product.
Failure to do so could result in death or electrical shock.
General information
WARNING
The models may be powered at 240V or 208V.
This rangetop does not require a neutral connection. If the
rangetop is to be completely enclosed in a cabinet, feed the
cooktop cable through the opening in the cabinet. Make the
electrical connection following the appropriate steps for your
installation.
Your rangetop must be connected to the proper electrical
voltage and frequency as specified in the table on the right.
LOCATION OF SERIAL TAG
Connect with copper wire only
If the house has aluminum wiring, follow the procedure below:
1. Connect the aluminum wiring to the copper wire by using
special connectors designed and Underwriters Laboratories-
listed for joining copper to aluminum. Follow the electrical
connector manufacturer’s recommended procedure.
2. Aluminum/copper connection must conform with local
codes and industry- accepted wiring practices.
The flexible conduit (supplied) 3 feet long (100 cm) located at
the right rear of the cooktop bottom box should be connected
directly to junction box. Do not cut the conduit. A U.L - or CSA
- listed conduit connector must be provided at each end of the
power supply cable (at the cooktop and at the junction box.) A
time delay fuse or circuit breaker is recommended.
Do not ground to a gas pipe. Do not have a fuse in the
grounding or neutral circuit.
Fuse both supply (phase) lines.
WARNING
Improper connection of aluminum house wiring to the copper
leads can result in a serious problem.
Model
Power Supply
240 V 60 Hz 208 V 60 Hz
30“
7.20 kW 30 A 6.45 kW 31 A
36“
10.80 kW 45 A 9.80 kW 47 A
National Fire Protection Association Batter/march Park
Quincy, Massachusetts 02269
A three-wire, single phase, 240 Volt 60 cycle electrical system
(properly circuit protected to meet Local Codes of NFPA
No.70) must be provided. Unit must be properly grounded
in accordance with local wiring code. The chart below
recommends the minimum circuit protector and wire size if the
appliance is the only unit on the circuit. If smaller sizes of wire
are used, the unit efficiency will be reduced and a fire hazard
may be created. It is advisable that the electrical wiring and
hookup be accomplished by a competent electrician.
Recommended Minimum
kW Rating on
serial plate
Circuit protection
in amperes
Wire size
(AWG)
0.1 - 4.8 20 12
4.9 - 6.9 30 10
7.0 - 9.9 40 8
10.0 - 11.9 50 8
12.0 - 14.9 60 6
Be sure your appliance is properly installed and grounded by a
qualified technician.
Ask your dealer to recommend a qualified technician or an
authorized repair service.
This rangetop does not require a neutral connection.
If the cooktop Is to be completely enclosed In a cabinet, feed the
cooktop cable through the opening in the cabinet.
Make the electrical connection following the appropriate steps
for your installation.
This appliance is manufactured with a green ground wire
connected to the cooktop chassis.
After making sure that the power has been turned off, connect
the flexible conduit from the appliance to the junction box
using a U.L. listed conduit connector.
The instructions provided below present the most common way
of connecting the cooktops.
Your local codes and ordinances, of course, take precedence
over these instructions. Complete electrical connections
according to local codes and ordinances
Loading ...
Loading ...
Loading ...