Loading ...
Loading ...
Loading ...
12 | Page
OPERATION INSTRUCTIONS
BEFORE USING YOUR PORTABLE AIR CONDITIONER
• Remove the exterior and interior packaging.
• Before connecting the unit to the power source, let it stand upright for a minimum of 4 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
SWITCHING ON/OFF THE AIR CONDITIONER
The unit can be switched ON or OFF by pressing the Power button on the control panel or the
Power button on the remote control.
DEHUMIDIFYING MODE
• In this mode, the air conditioner dehumidifies the room, the compressor will activate intermittently
depending on the ambient temperature and the fan speed is set to Low.
• To activate dehumidifying mode, press the Mode Control button until the PURPLE indicator
illuminates. When switching between functions, there will be an approximate 3 minute transition
time.
• In dehumidifying mode, the exhaust hose does not need to be vented. If the exhaust hose is vented,
the room will be cooled as it dehumidifies. To prevent cooling, remove the exhaust hose from the
window kit and allow the warm air from the rear to be re-circulated into the room. If room
temperature is higher than 77°F, the fan speed can be adjusted. If room temperature is lower than
77°F, the fan speed is set at Low.
• Note:
• When using dehumidifying mode, venting the exhaust hose to the outside is not required. If vented,
the warm air is exhausted to the outside and cooling within the room may occur. Additionally, if the
exhaust hose is not vented, the unit may require more frequent draining.
• The air conditioner does not have a humidistat in which a specific humidity level can be set.
FAN
ONLY MODE
• In this mode, only the fan of the air conditioner runs and circulates the air within the room. To
activate fan only mode, press the Mode Control button until the YELLOW indicator illuminates.
In this mode, the temperature cannot be set. Subsequently, set the desired fan speed by
pressing the Fan Speed button.
• Note: When using fan only mode, venting the exhaust hose to the outside is not required.
COO
LING MODE
In this mode, the air conditioner cools and dehumidifies the room. To activate the cooling function,
press the Mode Control button until the indicator illuminates. When cooling mode is set, the
compressor will start in approximately 3 minutes.
NOTE: In cooling mode, hot air is exhausted from the outdoor exhaust port and the exhaust hose must
be connected to exhaust out the hot air.
The temperature setting range of this air conditioner is from 61°F to 89°F. To set the temperature,
press the + or - buttons. This air conditioner has a 5°F temperature cushion; if the set temperature is
within 5°F of the ambient temperature, the unit runs in fan only mode. This saves energy and prolongs
the life of the compressor of the air conditioner. Once the set temperature is achieved, the compressor
will turn off and the fan runs continuously to circulate the air within the room.
To set the fan speed, press the Fan Speed button.
Note: When the compressor is running, the sound difference between each fan speed is not very
noticeable.
Loading ...
Loading ...
Loading ...