Loading ...
Loading ...
Loading ...
11EN
1 Connect your Wi-Fi enabled device to
your existing home Wi-Fi network.
2 Launch the Internet browser (for example,
Apple Safari or Microsoft Internet
Explorer) on your Wi-Fi enabled device.
3 Open the conguration page of your
home Wi-Fi router.
4 Find the Wi-Fi settings tab and write down
the following information on paper:
A Network name (SSID)
B Wi-Fi security mode (usually WPA or
WPA2 if enabled)
C Wi-Fi password (if Wi-Fi security is
enabled)
D DHCP mode (enabled or disabled)
E Static IP address settings (if DHCP
mode is disabled)
Switch AD7050W to Assisted Wi-Fi
Setup mode
Note
• Before you press any button on AD7050W, make sure
that AD7050W has been booted up successfully (see
'Turn AD7050W on' on page 7).
• Press and hold Wi-Fi SETUP on the back
of the device.
» The Wi-Fi SETUP indicator blinks
yellow and green.
» A new Wi-Fi network created by
AD7050W will appear, with the
network name (SSID) of Philips
AD7050W.
» It may take up to 30 seconds for
successful creation of this new Wi-Fi
network.
Note
• After you nish manual Wi-Fi setup for AD7050W,
the new Wi-Fi network created by AD7050W will
disappear.
• If you fail to enter Assisted Wi-Fi Setup mode, power
off AD7050W and power on it, then try again after
successful boot-up.
• Make sure that there are no other Philips AirPlay-
enabled devices in Assisted Wi-Fi Setup mode at the
same time. Multiple Wi-Fi networks created this way
may interfere with each other.
Connect your Wi-Fi enabled device to
the newly created Wi-Fi network
The new Wi-Fi network created by
AD7050W only allows access of one Wi-
Fi enabled device. To avoid interference
from any other Wi-Fi devices, you are
recommended to temporarily disable the
Wi-Fi function on your other Wi-Fi devices.
Option 1: Use your iPod touch/iPhone/iPad
1 Select Settings -> Wi-Fi on your iPod
touch/iPhone/iPad.
Loading ...
Loading ...
Loading ...