Loading ...
Loading ...
Loading ...
6
• Do not operate the engine in an enclosed area, even
if doors or windows are open.
4. Make sure that the operating area is clear of bystanders,
especially children.
WARNING
This snowthrower is capable of amputating hands and feet,
and throwing objects. Read and obey the safety instructions
in this manual. Failure to do so could result in death or
serious injury.
• Keep children out of the area during operation.
• Children are often attracted to the equipment. Be
mindful of all persons present.
• Be alert and turn the unit off if bystanders enter the
area.
• Use extra care when you approach blind corners,
shrubs, trees, or other objects that can obscure vision.
Engine
Oil Recommendations
Oil Capacity:
See the
Specifications
section.
NOTICE
Some engines are shipped from Briggs & Stratton with or
without oil. Always make sure that the engine has oil. If you
start the engine without oil, it will be damaged beyond repair
and will not be included under the warranty.
We recommend the use of Briggs & Stratton
®
Warranty
Certified oils for best performance. Other high-quality
detergent oils are permitted if classified for service SF, SG,
SH, SJ or higher. Do not use special additives.
Outdoor temperatures determine the correct oil viscosity
for the engine. Use the chart to select the best viscosity for
the outdoor temperature range expected. Engines on most
outdoor power equipment operate well with 5W-30 Synthetic
oil. For equipment operated in hot temperatures, Vanguard
®
15W-50 Synthetic oil gives the best protection.
Check and Add Oil
NOTICE
Some engines are shipped from Briggs & Stratton with or
without oil. Always make sure that the engine has oil. If you
start the engine without oil, it will be damaged beyond repair
and will not be included under the warranty.
Use Briggs & Stratton
®
Synthetic 5W-30 Warranty
Certified oil for best performance. Other high-quality
detergent oils are permitted if classified for service SG, SH,
SJ or higher. Do not use additives.
1. Put the unit on a level surface (Figure 3).
3
2. Clean the oil fill area.
3. Remove the dipstick (A, Figure 4). Use a clean cloth to
remove oil from dipstick.
4. Install the dipstick, and check the oil level. Make sure that
the oil level is at the top of the FULL indicator (C).
5. If the oil level is below the FULL indicator, carefully add
oil into the engine oil fill tube (B). DO NOT add too much
oil in the oil fill tube.
6. Wait one minute. Check the oil level again.
7. When the oil level touches the top of the FULL indicator,
install and tighten the dipstick.
A
SAE 30 - Below 40 °F (4 °C) the use of SAE 30 will result in hard
starting.
B
10W-30 - Above 80 °F (27 °C) the use of 10W-30 may cause
increased oil consumption. Check the oil level frequently.
C 5W-30
D Synthetic 5W-30
Vanguard
®
Synthetic 15W-50
E
Loading ...
Loading ...
Loading ...