Loading ...
Loading ...
Loading ...
10
Surface Cooking (Continued)
Models with Ceramic Glass Cooktop
(continued)
Operating the Dual Surface Radiant Element
(Models with Ceramic Glass Cooktop Only)
Models A & B (See Page 8) are equipped with a dual radiant
surface element located at the right front (See Figures 7 & 8)
position. Symbols on the control panel are used to indicate which
coil of the dual radiant element will heat. The symbol
indicates that only the inner coil will heat (Figures 1, 3 and 4).
The symbol indicates that both inner and outer coils will heat
(Figures 5, 7 and 8). You may switch from either coil setting at
any time during cooking.
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the dual surface element.
2. Push in and turn the control knob counterclockwise (See
Figure 2) for smaller cookware or clockwise (See Figure 6)
for larger cookware.
3. Turn the knob to adjust the setting if needed. Start most
cooking operations on a higher setting and then turn to a
lower setting to finish cooking. Each surface element
provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is too
small for the surface heating area.
4. When cooking has completed, turn the surface control knob
to OFF before removing the cookware. Note: The Surface
Indicator light will come on when the control knob will be
turn on and will continue to glow until the glass cooktop has
cooled down to a moderate level. The light may remain on
even though the controls are turned OFF.
Note: See page 9, Figure 1 for recommended control settings.
Operating the Bridge Surface Radiant Element
(Model A Only)
Model A (See Page 8) is equipped with a “BRIDGE” surface
element located at the left front and middle (See Figure 12)
positions. The Bridge can be used when cooking with rectangular
(like a griddle) or oval shaped cookware. The element will
maintain an even temperature setting across both portions of the
Bridge. If needed for normal cookware, the Bridge element can
work like a single element without the Bridge (See Figure 10).
Bridge element operation symbols are located on the control
panel on each side of the Bridge element control knob. These
symbols indicate the direction to turn the control knob when
operating the Bridge element. The symbol in Figure 9 indicates
that only the single portion of the Bridge element will heat
(Figure 10). The symbol in Figure 11 indicates that both the single
and Bridge portions of the element will heat together (Figure 12).
You may switch from either of these settings at any time during
cooking with the Bridge element.
Figure 2
Figure 10
Bridge element without
Bridge portion.
Figure 12
Bridge element with Bridge
portion.
Figure 9
Figure 11
Figure 1
Figure 3 - Model A
Figure 5
Figure 6
Figure 7 - Model A
Radiant surface elements may appear to have
cooled after they have been turned off. A hot surface indicator
light will come on and will continue to glow until the glass
cooktop has cooled down to a moderate level. The glass
surface may still be hot and burns may occur if the glass
surface is touched before the indicator light has turned off.
Figure 4 -Model B
Figure 8 - Model B
Loading ...
Loading ...
Loading ...