Loading ...
Loading ...
Loading ...
Dishwasher / User’s Manual
31 / 48
EN
OperatJng the product
C
Pay attention not to open the
door of the machine when it
is running. Stop the machine
by pressing the Start/Pause/
Cancel key if you have to open
the door. Then, open the door
of the machine. There may be a
rush of vapour when you open
the door of your machine; be
careful. Close the door of your
machine and press Start/Pause/
Cancel key again. Programme will
resume running.
Changng the programme
To change a running programme, you
should cancel the programme in the first
place. Then, you can select and start a new
programme.
Cancellng the programme
1. Press and hold the Start/Pause/
Cancel key for three seconds while the
programme is running.
2. Release the key when the Start/Pause
indicator starts flashing. For a couple
of minutes, the machine will fulfill the
necessary operations required to cancel
the programme. Once the programme
is cancelled, "0:00" will appear on the
Remaining Time indicator.
C
You can select and operate
a new programme after the
programme is cancelled.
C
There might be residues of
detergent or rinse aid left in the
machine and/or on the pieces
being washed depending on the
step the previous programme
was in at the time of such
cancellation.
Overflowing Warning
If the machine intakes
too much water or there is leakage at any
of the components, then the machine
will detect this and E:01 icon will flash on
the Programme indicator. As long as the
overflowing continues, the safety algorithm
will be active and try to discharge the water.
If overflowing stops and safety is assured,
E:01 icon will disappear. If E:01 does not
disappear, there is a permanent fault. In
this case, the authorised service should be
contacted.
Salt Indcator ( )
Check the Salt indicator on the display to see
whether there is enough softening salt in
your machine or not. You need to refill the
salt container whenever the Salt indicator
lights.
C
Adjusting the water hardness
level is explained in the Water
Softening System section.
Rnse Ad Indcator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or not.
You need to refill the rinse aid dispenser with
rinse aid whenever the rinse aid warning
symbol lights.
C
Rinse aid warning will go
off automatically once the
programme is started.
Loading ...
Loading ...
Loading ...