Loading ...
Loading ...
Loading ...
6
Quick Installation Guide
13 Mount the UWP and close the door.
Mount the UWP using the provided
screws. Install all three screws into
the wall anchors for a secure fit on
your wall. Close the door after you’re
finished.
14 Confirm wiring matches snapshot.
Please confirm wiring matches
terminals from the photo you took in
Step 5.
Use 3x supplied
screws (#8 11/2
for red anchors
and #6 11/2 for
yellow anchors)
1/4” to 3/8”
15 Install batteries.
Insert three AA alkaline batteries in the back of the thermostat as shown.
NOTE: The RTH8500 thermostat works in battery mode or normal power
mode if a C-wire is available.
16 Attach your thermostat.
Align the thermostat onto the UWP
and firmly snap it into place.
12 Connect wires from Step 7.
Depress the tabs to put the wires into
the inner holes of their corresponding
terminals on the UWP (one wire per
terminal) until it is firmly in place.
Gently tug on the wires to verify
they are secure.
Tip: If you need to release the wires
again, push down the terminal tabs
on the sides of the UWP.
This wiring is just an example,
yours may vary.
Loading ...
Loading ...
Loading ...