Loading ...
Loading ...
Loading ...
CARE & USE/INSTALLATION
|
12 13
|
CARE & USE/INSTALLATION
The grill arrives nearly ready to use and requires only minor
assembly.
By carefully following the uncrating and unpacking steps,
you will improve the customer’s first Lynx experience.
Shipping weight on smaller units is app. 300 pounds and
larger units may weigh over 500 pounds.
CRATE & CARTON
• IMPORTANT! Do not remove staples around the top of
the carton. These staples hold a wooden pallet in place
inside the carton that protects the unit from damage.
Removing these staples may cause the pallet to fall on
the top of grill.
How to Remove the Carton
• Cut the main strap holding the grill to the pallet.
• Remove the staples at the bottom of the carton.
• Lift off the carton.
• With assistance, remove the grill from the pallet and
place into desired location.
The wheels sit down in the gaps of the shipping crate so
that the grill can sit safely and solidly on the crate during
shipping. The grill cannot be slid directly off of the pallet.
One way to safely move the grill off of the pallet is by lifting
one end of the grill high enough to place a ramp under the
wheel and then lift the other end while rolling the grill off of
the pallet.
When pushing, lifting,
or pulling a freestand-
ing Lynx Grill across
gravel, grass, pavers,
brick, stone,
imperfections in the surface, or wood slatted decks be
cautious and move slowly or use a carpet dolly. Failure to
do so may damage the structure of the cart which will not
be covered under warranty.
INTERIOR PACKING
Lynx uses sturdy tie-down cables and straps to ensure
your grill arrives at your home in the same condition that
it left our factory. BE SURE YOU HAVE REMOVED ALL TIE
DOWNS BEFORE USING YOUR GRILL.
• Remove the white accessory box and wood packing, the
grill racks, and remove any loose items from the firebox.
• Carefully cut the able ties securing the warming rack and
rotisserie spit.
• Cut the strapping that secures the briquette trays and
carefully lift them out, front first.
Make sure you remember to remove the strapping on the
burners.
• On Trident ™ burner models, cut and remove ties from
the burner partition on the left side of the Trident ™
burner.
• Ensure that all burners are properly seated on the burner
valve orifice and sitting level with the legs in the frame
slots and no side-to-side movement.
UNPACKING & ASSEMBLY
Use two or more people to move or install this
unit. Failure to follow this instruction can result in
back or other personal injuries.
WARNING:
EXCESSIVE WEIGHT HAZARD!
Grill will not
slide directly
off pallet.
Inside View, Orifice all
the way into venturi
Heat Shield Removed,
Orifice/Venturi Position
Orifice all the way
into the venturi
UNPACKING & ASSEMBLY ...continued
Move the rear caps towards the back and pull the
front caps forward
Burner sitting flat
Remove Pink Foam
Tie Down
Loading ...
Loading ...
Loading ...