Loading ...
Loading ...
Loading ...
en Troubleshooting
30
Errors Cause Troubleshooting
The base of the refrigerator
compartment is wet.
The condensation channel
or drainage hole are
blocked.
▶
Clean the condensation channel
and the drainage hole. →Page27
Information on display panel
Errors Cause Troubleshooting
Message showing "D" or "E"
appears in the display.
The electronics have detec-
ted a fault.
▶
Call the after-sales service.
→"Customer Service", Page32
The temperature display
(freezer compartment)
flashes.
The temperature in the
freezer compartment was
too warm.
1. Press .
a The temperature display (freezer
compartment) briefly indicates the
warmest temperature reached in
the freezer compartment. The tem-
perature display (freezer compart-
ment) then indicates the set tem-
perature again.
2. Press .
a The temperature display (freezer
compartment) no longer flashes.
The temperature display
(freezer compartment)
flashes, a warning signal
sounds and lights up.
Different causes are pos-
sible.
▶
Press .
a The alarm is switched off.
The appliance door is open.
▶
Close the appliance door.
The ventilation openings are
covered up.
▶
Remove any obstructions from in
front of the ventilation openings.
Larger quantities of fresh
food have been put in.
▶
Do not exceed the max. freezing ca-
pacity.
→"Freezing capacity", Page23
Temperature problem
Errors Cause Troubleshooting
The temperature differs
greatly from the setting.
Different causes are pos-
sible.
1. Switch off the appliance.
→Page19
2. Switch the appliance back on after
fiveminutes. →Page19
‒ If the temperature is too
warm, check the temperature
again after a couple of hours.
‒ If the temperature is too cold,
check the temperature again
on the following day.
Loading ...
Loading ...
Loading ...