Loading ...
Loading ...
3
INSTALLATION INSTRUCTIONS
1. Check washer and dryer spacing
NOTE: Before you begin, set aside the rolled-up rubber mat
that came with your worksurface until later.
Check the spacing between your washer and dryer.
If necessary, move your washer or dryer so that there
is a space of approximately 1" (25 mm) between them.
2. Check washer and dryer levelness
Check that the washer and dryer are level front to back and side
to side and the difference in height is no more than 3/8" (9.5 mm).
Place a level on both the washer and dryer to determine any
difference in height. If necessary, see the Installation Instructions
that came with your washer and dryer to properly adjust the
leveling feet.
Not Level LEVEL Not Level
3. Put worksurface into place
Place the worksurface on top of the washer and dryer. Align
the front edge of the worksurface with the seam between the top
of the washer/dryer and the control panel. Center it left to right
so that the alignment pads t in the space between the washer
and dryer.
Seam
4. Put rubber mat in place
Check that the top of the washer and the bottom of the rubber
mat are clean and set mat in place on top of the worksurface.
IMPORTANT: Dispose of/recycle all packaging materials.
Loading ...
Loading ...
Loading ...