Loading ...
Loading ...
Loading ...
Care and Cleaning
Under Refrigerator Behind Refrigerator
For most efficient operation,
you need to keep the area under the
refrigerator clean. Remove the base
grille and either sweep away or
vacuum up dust that is readily
accessible on the condenser coils.
To remove the base grille, open
both doors, grasp the bottom of
the grille and pull it out.
To replace the base grille,
line up the clips on the back
of the grille with the openings
in the baseplate and push the
grille forward until it snaps
into place.
Care should be taken in moving your refrigerator away from the wall.
All types of floor coverings can be damaged, particularly cushioned
coverings and those with embossed surfaces. Pull the refrigerator
straight out and return it to position by pushing it straight in. Moving
your refrigerator in a side direction may result in damage to your floor
covering or refrigerator.
When pushing the refrigerator back, make sure you don’t roll over the
power cord or icemaker supply line.
Clean the condenser coils
at least once a year.
Drawer and Cover Removal
Drawers will stop before coming all the way out of the refrigerator to
help prevent contents from spilling onto the floor. Drawers can easily
be removed by tilting up slightly and pulling past the “stop” location.
Remove the door bins from the fresh food door before removing
the drawer.
To remove the shelf above the top
drawer, first remove the top drawer
and any food on the shelf. Then tilt
the shelf up at the front and lift it up
and out of the tracks.
To replace the shelf, raise the
shelf front slightly and place the
top hooks in the lowest large track
slots. Then lower the front of the
shelf until it is level.
When replacing the drawers, make
sure you slide them through both
drawer guides on the right side.
To remove the drawers when the
fresh food compartment door
cannot be opened fully you need to
roll the refrigerator forward until
the door can be fully opened. In
some cases this will require moving
the refrigerator to the left as you roll it out.
Drawer
Guides
13
Light Bulb Replacement
Fresh Food Compartment—Upper Light
1. Unplug refrigerator.
2. Remove the snap-in light shield.
3. Replace with same size bulb and reinstall the light shield. If you
cannot locate the correct bulb, see your dealer.
Fresh Food Compartment—Lower Light (on some models)
This light is located behind a shield at the rear of the fresh food
compartment.
1. Unplug the refrigerator.
2. Grasp the top edge of the shield and lift it up and forward to free its
top edge.
3. After replacing with the same size bulb, hook the top of the shield
back in place. If you cannot locate the correct bulb, see your dealer.
4. Plug the refrigerator back in.
Freezer Compartment with a Dispenser
1. Unplug the refrigerator.
2. Remove the shelf just below the light shield. (The shelf will be
easier to remove if it is emptied first.)
3. Pull the light shield toward you to reach the bulb.
After replacing with same size bulb, reinstall shelf and plug the
refrigerator back in.
1
3
5
7
9
1
3 5
7
9
Loading ...
Loading ...
Loading ...