Loading ...
Loading ...
Loading ...
9001050650 Rev A English 5
Procedure for an Electric or
Induction Slide-In-Range (Low
Backguard, Electric and
Induction HEBZS301)
Tools Needed
• Torx T20 screwdriver
•gloves
Preparation
9 IMPORTANT!
Can you slide the range out enough to have access to the
rear and side rear trim screws?
• If you can slide the range out, continue with the
procedure,
• If you cannot slide the range out, contact a qualified
service person to disconnect the electrical connections
that prevent the range from being pulled out before
continuing with the procedure.
• Read the Tip Over Warning in the Safety Section of this
manual. Be aware of this when the range has been
pulled out of the anti-tip bracket for this installation.
Procedure
1. Confirm that the range is cool enough to be
comfortably touched at the rear.
2. Slide the range out enough to access the trim mounting
screws.
3. Remove the screws holding the trim (five screws on the
back and one screw on each end). Save these screws
for installing the Low Backguard.
Figure 5: Trim screw locations
4. Lift the trim off.
5. Lower the Low Backguard into place, aligning the holes
at 1 with the holes at 2 on both sides of the range.
Figure 6: Low Backguard placement
6. Secure the Low Backguard with one screw at each end
and then hold the Low Backguard in a vertical position
while securing the 5 screws in the back.
7. If necessary, have a qualified service person reattach
the electrical connections.
8. Slide the range back into position.
9. End of procedure.
Figure 7: Low Backguard in position
Loading ...
Loading ...
Loading ...