Loading ...
Loading ...
Loading ...
9
NOTES:
1. For best storage, be sure not to over-pack and assure the freezer door closes fully.
2. The glass shelves are adjustable. These shelves stop short an inch before the back wall, which
is essential for air flow and the proper operation of the automatic defrost system. Do not block
these gaps.
3. The interior light on this unit is controlled by a plunger type switch, so that the light comes on
automatically when the refrigerator door is opened.
4. If the unit is unplugged, has lost power or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
Defrosting Your Appliance
This appliance combines a manual defrost freezer section and an automatic defrost refrigerator
section. The refrigerator compartment defrosts itself, but when frost builds to ½ inch in the freezer
compartment, defrost carefully according to this procedure:
1. Remove contents from the entire unit, taking care that frozen items do not begin to thaw. Set the
thermostat to STOP (0).
2. Unplug the appliance. Defrosting is accelerated if the doors are left open.
3. Melting ice will drain into the drip tray below the freezer compartment. Empty this as needed.
4. Use a sponge or toweling to remove water and melting ice from the freezer floor. After the frost
or ice has melted, dry the interior of the freezer compartment thoroughly.
5. Restart the appliance by plugging it in and turning the thermostat to the desired position. Once it
is cold, return contents to the freezer and refrigerator sections.
CAUTION: Do not use boiling water or an electric device such as a hair dryer to help speed up the
defrosting process because this could damage the plastic parts of the unit. In addition,
never use a sharp or metallic instrument to remove frost as it may damage the cooling
coils and will void the warranty. We recommend using a plastic scraper.
CARE AND MAINTENANCE
Cleaning Your Appliance
1. Unplug the appliance, turn the thermostat to STOP (0) and remove all contents, including
shelves, drip tray and crisper.
2. Wash the inside surfaces with a solution of lukewarm water and vinegar. Wipe dry with a clean,
soft cloth.
3. Wash the shelves, drip tray and crisper with a mild detergent solution, then rinse and dry
thoroughly.
4. Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
5. Wring excess water out of the sponge or cloth before cleaning the area
of the temperature control or any electrical parts.
6. From time to time, wipe the condenser on the rear wall with a soft non-
metallic brush or vacuum cleaner.
7. After you have cleaned the appliance, reconnect it to the power supply,
reset the thermostat and return all contents to their place.
Loading ...
Loading ...
Loading ...