Loading ...
Loading ...
Loading ...
Product Assembly
18
Product Assembly
Only loosely tighten ALL BOLTS until STEP 8
STEP 7 – Preparing to Fully Tighten the Upright Posts
a. Before fully tightening to Torque Specs in STEP
8, gently hand screw in half-way, all 4 Allen Head
Bolts, M8 x 20mm on both sides of the Upright
Posts to the Base Frame Assembly (001-ASM)
and the Dashboard Assembly (077-ASM), See
Fig. 9 image.
b. Snug up both front and rear bolts with the 6mm
Allen Wrench. This will ensure during the
tightening to Torque Specs on the other bolts, the
hole alignment to bolts will not go off when
installing the plastic Handle Bar Covers both
#141 & #142 during STEP 9a and Step 9b.
Note: Cross threaded bolts and/or stripping out the
pre-threaded holes M8mm x 1.25p will not be covered
under warranty due to installation alignments.
Fig. 9
c. Then unscrew out the 2 each side
bolts from Upright Post - Right
(064) and 2 each side bolts from
Upright Post - Left (063) before
continuing to STEP 8. Double
confirm the outer opening holes
leave room for the bolt threads to
line up with the inner threaded
holes. See pic on Fig. 10.
Fig. 10
Loading ...
Loading ...
Loading ...