Loading ...
Loading ...
Loading ...
77
- Some capsules may not work with this appliance. If the capsule does
not properly fit into the Capsule Holder, or leaks during the brewing
cycle, do not use that type of capsule again.
4. Press the Lid down into the lock position to close the Lid.
5. Place the Drip Tray with Cup Holder in either the upper, middle or lower Mounting Slots.
Ensure it is securely in place when using the middle or upper Mounting Slots and sits
flat when using the lower Mounting Slots.
6. When using the Ground Coffee Holder , ensure it contains the required amount of
ground coffee. Fill with ground coffee up to the MAX fill line. Do not overfill it. Do not
compress the ground coffee in the Ground Coffee Holder. Do not use ground coffee for
Espressos, as it is too fine and can clog the Ground Coffee Holder. Insert the Ground
Coffee Holder in the Insert Holder.
NOTE:
- Use the lower Mounting Slots when using large mugs and the upper or
middle Mounting Slots when using small cups.
- When removing the Water Reservoir with Lid close the Lid. rside of the
Lid or inside the Capsule Holder, they are sharp.
7. Lift the Water Reservoir With Lid and remove it from the appliance. Remove
the lid from the Water Reservoir With Lid.
8. Fill the Water Reservoir With Lid with fresh cold water and then refit the Water
Reservoir With Lid afterward.
WARNING:
- Do not over or under fill the Water Reservoir With Lid. Ensure the water
level is always between the Min (6oz) and MAX (30oz) markings on the
Water Level Indicator. Remove the water reservoir and drain excess
water if needed.
9. Securely place a cup/mug in the center of the Cup Holder.
10. Insert the Power Cord With Plug into a wall outlet. All indicator lights will flash 3 times,
followed by the appliance switching to stand-by mode with all indicator lights off.
Loading ...
Loading ...
Loading ...