Loading ...
Loading ...
Loading ...
116 Part Number STH14 9/10
THE 6 PROGRAMMING MODES ON FLEXTOWER
CONTROL BOARD
Program Mode 1= Manual Dispense Mode
Program Mode 2= Timed Dispense Mode or Flavor
Adder Mode
Program Mode 3= Water Calibration Mode
Program Mode 4= Syrup Calibration Mode
Program Mode 5= Touchpad Configuration Mode
Program Mode 6= Touchpad LED Light Sequencing
Mode
To Access Programming Modes
To enter programming modes, press and hold the
control board program button for a minimum of 3
seconds. Control board LED displays a number (1) for
manual dispense mode. To select another
programming mode, press and release the control
board program button once to enter the next
programming mode. Repeat pressing and releasing
the control board program button until desired
program mode is entered.
To Exit Programming Modes
To exit programming modes and to save programming
mode changes, press and hold control board program
button for a minimum of 3 seconds. Control board LED
displays (0) for run or dispense mode.
Manual Dispense Mode
(Finished Noncarbonated Drink Dispensed)
Once in program mode (1), the control board LED
displays (1). Press any touchpad selection area two
times in less than three seconds and selection area
LED lights will blink twice to indicate the touchpad
area has been programmed for manual dispense. The
procedure can be repeated for other touchpad
selection areas needing programmed for manual
dispense. After all designated touchpad areas have
been programmed for manual dispense either enter
another program mode or exit the programming
modes, which will save programming mode changes.
STH14.book Page 116 Thursday, September 23, 2010 3:35 PM
Loading ...
Loading ...
Loading ...