Loading ...
Loading ...
Loading ...
10
INSTALLATION INSTRUCTIONS
Installation
WARNING!
This appliance is heavy and requires two persons for unpacking and installation
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards.
Failure to install the screws or fixing device in accordance with these instructions
mayresult in electrical hazards.
IMPORTANT!
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
1
Preparing for installation:
Before installing your rangehood:
Please read the instructions carefully.
Unpack the rangehood.
Ensure the voltage (V) and the frequency (Hz) indicated on the serial plate match
thevoltage and frequency of the installation site.
Check all functions are working.
Check that the area behind the installation surface to be drilled is clear of any
electrical cables or pipes etc.
The rangehood surfaces can be damaged during installation if grazed or knocked
bytools. Please take care to protect the surfaces during installation.
Protect the cooktop surface with cardboard, or the like, to prevent damage
occurringwhilst the rangehood is being installed above.
Temporarily mark the height of the bottom of the rangehood and the centre of
the cooktop on the wall according to the information given in the ‘Installation
instructions– Height of rangehood’ section.
The wall used for mounting the rangehood should have sufficient strength and a
flatsurface.
2
Attach chimney brackets and rangehood
mounting screws to the wall
Attach the chimney bracket and upper
chimney bracket (if using the upper
chimney) in the locations shown in
Fig. 2 and 3. Use the 30mm screws (and
expansion plugs if attaching to masonry).
Attach the upper rangehood mounting
screws in the locations shown in Fig. 2
and3. Using the 30mm screws (and
expansion plugs if attaching to masonry).
Ensure that there is a 2mm gap between
the screw head and the wall (see Fig 1).
Fig.1
2 mm
2 mm
Loading ...
Loading ...
Loading ...