Loading ...
Loading ...
Loading ...
problems & solutions
16
Check the solutions below before contacting your supplier or our technical department in case of a problem.
Problem Solution
The microwave oven does not
start
Is the power cord plugged in?
Is the fuse or circuit breaker blown?
The microwave oven does not
heat
Did the door close correctly? Open the door and shut it well again.
The turntable makes noise Clean the roller ring for the turntable and the bottom of the microwave oven.
The food is not well defrosted Has the power and time been set correctly? Did you stir or turn the food at least once whilst
defrosting?
installation instructions
17
• The safety during use can only be guaranteed when the hob is installed correctly and according to the regulations. The installer is
responsible for any damage caused by a faulty installation.
• The electrical connection must be made by a qualified electricien. This person is aware of the national and local regulations the
installation must comply with.
• The appliance falls under protection class I and can only be used in combination with a grounding conductor connection. The
manufacturer accepts no responsibility for any malfunction or damage caused by incorrect electrical installations.
• The appliance must be connected to a fixed installation and the means of disconnecting it from the fixed installation must be
installed according to the installation instructions.
• The connection cable must hang freely. Do not tie the power cable or pass it along sharp edges. It must be positioned so that it
does not touch any of the hot parts of the microwave oven.
• The connection point, the wall socket and/or plug must always be accessible.
• The cabinet into which the microwave is fitted, must be heat resistant (> 75°C).
• Ensure that the cabinet into which the microwave oven is installed is secure. For example, by mounting it to the adjoining elements.
• Damage caused by incorrect connection, incorrect use or incorrect fitting is not covered by the guarantee.
Attention: any change to the appliance’s interior, including fitting and changing the power cable, must only be performed by a
qualified electricien.
cleaning & maintenance
15
Before cleaning the microwave oven be sure to switch it off and unplug it. Leave the microwave ovento cool down completely.
Interior
Clean the inside of the appliance after every use. Use a damp cloth. For a thorough cleaning use warm soapy water and dry the interior.
Accessories
Clean the separate accessories such as the turntable, the roller stay and the grill rack with warm soapy water. These accessories can
also be cleaned in the dishwasher. Thoroughly dry everything before using them again.
Exterior
Clean the exterior of the appliance with a damp cloth or sponge. If necessary use a mild detergent. Also clean the door and the door
seal.
ELECTRICAL CONNECTION
Check that the voltage in your home corresponds with the voltage printed on the appliance.
These groups in the meter must be secured with at least 16 amps each. The connection cable must have a cross-section of at least
2.5mm² and must have a length of at least 1.5 m. When the cable is too short, you have no room to already connect the oven and place
it against the wall before plugging it in.
Loading ...
Loading ...
Loading ...