Loading ...
Loading ...
Loading ...
Frequently Asked Questions
58
Message Possible cause and solution
Clean plinth filter.
See lights up
after a program
has been inter-
rupted.
An excessive amount of lint has built up.
Clean the lint filters.
Clean the plinth filter.
Clean the air duct area underneath the plinth filter.
Clean the heat exchanger.
To switch off the message:
Switch the dryer off and then on again.
Empty container See
lights up after
a program has
been interrupted.
The condensed water container is full or there is a
kink in the drain hose.
Empty out the condensed water container.
Check the drain hose.
To switch off the message:
Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
Blockage detected.
See lights up
after a program
has been inter-
rupted.
The laundry is unevenly distributed or has rolled up.
Open the door and untangle the laundry, and
remove a few items, if necessary.
Switch the dryer off and then on again.
Start a program.
Service Fault F
XXX lights up af-
ter a program
has been inter-
rupted.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program is interrupted again and an error
message appears, there is a fault. Contact Miele
Technical Service.
Loading ...
Loading ...
Loading ...