Loading ...
Loading ...
Loading ...
10
2. The prepared bare wire cable ends may be
inserted into spade lug connectors for use
outside the United States and Canada only.
3. Banana plugs are for use in the United
States and Canada only.
Banana Plugs are for use in the United States and
Canada only:
7. Locate the Terminal Connections Covers from the
inside of the MC462 shipping carton. Insert the
just prepared Loudspeaker hookup cables thru the
cover openings, one cover for each channel. Refer
to figure 5.
8. Attach the previously prepared bare wire cable
ends into the banana plugs and secure the connec-
tions. Refer to figure F.
9. Rotate the top of the Output Terminal
Post clockwise until it is nger tight.
Refer to gure G. Then using the Mc-
Intosh Wrench, rotate the top of the
Output Terminal one quarter of a turn
(90° ). Do not over tighten. Refer to
gure E.
14. Connect the Loudspeaker hookup cables to the
MC462 Negative Output Terminal and Positive
Output Terminal indentified as 2Ω (ohms), 4Ω
(ohms) or 8Ω (ohms) connection to match the
impedance of the Loudspeaker, being careful to
observe the correct polarities. Insert the spade
lug connector or prepared section of the cable end
into the terminal side access hole, and tighten the
terminal cap until the cable is firmly clamped into
the terminals so the lugs or wire cannot slip out.
Refer to figures 7 and 8.
Note: The illustration in figure 6 is connections for
8Ω (ohms) Loudspeakers.
If the Loudspeaker’s impedance is in-between
the available connections, use the nearest lower
impedance connection. Refer to “General Informa-
tion” Note 3 on page 2 for additional information.
10. Referring to figure H,
connect the Loudspeaker
hookup cables with ba-
nana plugs into the hole
at the top of the terminal
to the MC462 Negative Output Terminal and Posi-
tive Output Terminal indentified as 2Ω (ohms),
4Ω (ohms) or 8Ω (ohms) connection to match the
impedance of the Loudspeaker, being careful to
observe the correct polarities.
Note: The illustration in figure 5 is connections for
8Ω (ohms) Loudspeakers.
If the Loudspeaker’s impedance is in-between the
available connections, use the nearest lower imped-
ance connection. Refer to “General Information”
Note 3 on page 2 for additional information.
WARNING: Loudspeaker terminals are hazard-
ous live and present a risk of electric
shock. For additional instruction on
making Loudspeaker Connections con-
tact your McIntosh Dealer or McIn-
tosh Technical Support.
11. Attach the Terminal Connections Covers to the
MC462 Rear Panel with the previously removed
Screws. Refer to figure 5.
12. Connect the MC462 power cord to an active AC
outlet.
Spade Lug or Wire Connections:
13. Locate the Terminal Connection Covers from the
inside of the MC462 shipping carton. Insert the
just prepared Loudspeaker hookup cables thru the
cover openings, one cover for each channel. Refer
to figure 6.
Figure 7
Figure 8
Figure F
Figure H
Figure F
Figure H
Figure G
DISABLED
Figure 5 (Inside USA and Canada)
Cover Openings
Cover Openings
Cover Screws
Cover Screws
Figure 6 (Outside USA and Canada)
DISABLED
Cover Openings
Cover Openings
Cover Screws Cover Screws
Loading ...
Loading ...
Loading ...