Loading ...
Loading ...
Loading ...
6
INSTALLATION
Toe Grille Must
Fit in Slot On
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
Leveling Freezer Drawer (if necessary)
To level the freezer drawer:
1. Check gasket seal around top, bottom, and sides of freezer drawer.
2. If gasket is not sealed, open drawer and slightly loosen four (4) drawer screws (two (2)
on each side) to allow drawer to rotate.
3. Close drawer and recheck the seal
on the gasket (A). Open the drawer
grabbing by the sides in the center (B).
Be careful not to rotate the drawer.
4. Tighten four (4) drawer screws.
5. Recheck gasket seal.
Level Refrigerator & Adjust Doors (if necessary)
Guidelinesfornalpositioningofyourrefrigerator:
• Allfourcornersofthecabinetmustrestrmlyontheoor.
• The sides should tilt
1
/
4
inch (6 mm) from front to back (to ensure that doors close and seal
properly).
• Doors should align with each other and
be level.
Most of these conditions can be met by raising or lowering the
adjustable front rollers.
To level the cabinet using the
front rollers:
1. Slightly open freezer drawer. Lift the toe
grille and gently pull forward
(see illustration).
Grab
Drawer
at
Center
from
Both
Sides
then
Pull
Drawer
Out
Push
Against
Freezer
Drawer
A B
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Loading ...
Loading ...
Loading ...