Loading ...
Loading ...
Loading ...
26
Installation
Excessive ice has built up inside the
freezer compartment:
• The thermostat is set at too low a
temperature.
• The room temperature is too high.
• The door is being opened too often
or for too long.
• The door is not closing/sealing prop-
erly.
• The door seal is damaged or dirty.
Clean or replace it.
• Hot foods have been placed inside
the freezer compartment.
Doors are hard to open just after
closing:
• If you attempt to open the door again
just after closing it (especially the
freezer door), considerable strength
is required. This is due to the vacuum
created by the cooling of the warm
air which has entered the freezer.
The doors are misaligned:
• Check that the appliance is level.
• Level the appliance using its feet.
6 Installation
6.1 Electrical connection
Power voltage
Danger of electrocution
• The appliance must be connected to
ground in compliance with electrical
system safety standards.
• Do not pull the cable to remove the
plug.
General information
• Check the mains characteristics
against the data indicated on the
plate. The identication plate bearing
the technical data, serial number
and brand name is visibly positioned
inside the appliance.
Do not remove this plate for any
reason.
• Make sure that the plug and socket
are of the same type.
• Avoid using adapters, gang sockets
or extensions as these could cause
overheating and a risk of burns.
• The plug must always be accessible
when the appliance is installed.
• Leave the appliance standing vertical-
ly for at least two hours before turning
it on for the rst time.
• If it is necessary to replace the power
cable, this must be performed by an
authorised technician from Technical
Support Service.
Loading ...
Loading ...
Loading ...