Loading ...
Loading ...
Loading ...
© Pro-Ject Audio Systems · Pro-Ject RPM 3 Carbon / Ortofon 2M SILVER · Revision 2015.02.02
7
cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber
parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.
If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.
!
Always disconnect the record player from the mains power supply as a precaution before maintenance!
Fitting and connecting the cartridge
** All cartridges with half inch mounting holes can be fitted. Leaving the needle's protection cover on, fit the
cartridge to the headshell using the screws supplied with the cartridge by passing one screw through each
slot in the headshell (14). Do not tighten the nuts yet.
Connect the tonearm wires to the cartridge pins as follows:
white left channel positive (L+)
red right channel pos. (R+)
green right channel return (R -)
blue left channel return (L -)
The full sound quality of the record player can only be achieved if the cartridge is correctly adjusted. Particular
tools like the Pro-Ject Alignment Tool are required to accomplish this job properly.
If you are not well acquainted with the adjustment of cartridges you are advised to call upon the willing help of
your Pro-Ject dealer to accomplish this task for you.
Please note: adjusting a cartridge and tonearm calls for the greatest care in order to avoid damaging
the cartridge or tonearm bearings. Leave this work to your dealer if you are in any way unsure of the
necessary steps and precautions to be taken.
Useful tips
The record player should be positioned on a low-resonance surface such as wood or multiple layer ply board
to avoid structural vibrations disturbing replay.
Technical specifications Pro-Ject RPM 3 Carbon / Pro-Ject 10s Carbon
Nominal speeds
33/45 r.p.m.
Speed variance
33: 0,14% 45: 0,11%
Wow and flutter
33: 0,19% 45: 0,08%
Signal to noise
-71dB
Effective tonearm mass
16g
Effective tonearm length
10 " (254mm)
Overhang
16mm
Power consumption
5 W max / < 0,5W standby
Outboard power supply
15V DC / 800mA , universal power supply
Dimensions (W x H x D)
447 x 118 x 373mm
Weight
5,5 kg net
Technical specifications MM-Cartridge Ortofon 2M Silver
Frequency range
20-22.000Hz
Channel separation
25dB/1kHz
Output voltage
5,5mV
Recommended load impedance
47kohms/amplifier connection – MM-input
Compliance/stylus type
20µm/mN – elliptical
Recommended tracking force
18mN
Weight
7,2g
Loading ...
Loading ...