Loading ...
Loading ...
Loading ...
10
B O S C H
13
Calc’n’Clean
Cleaning the Boiler
To extend the life of your steam generator
and to avoid any build up of scale, it is
essential that you rinse out the boiler after
several hours of use (approximately after
50 hours). If the water is hard, increase the
frequency.
Do not use descaling agents for rinsing out
the boiler, as they could damage it.
1. Check that the appliance is cold and
unplugged for more than 2 hours, and
that the water tank (1) is empty.
2. Place your appliance on the edge of
your kitchen sink, so that any residual
water in the water tank is directed into
the sink.
3. Remove the plastic cover located on the
bottom of the appliance by turning it to
the
position.
4. Unscrew the boiler drainage plug using
a coin.
5. Holding your steam generator in an
upside down position, and using a jug,
ll the boiler (in the base unit) with 1/4
litre of water.
6. Shake the base unit for a few moments
and then empty it completely over a sink
or bucket. To obtain the best result, we
recommend that this operation is done
twice.
Important: before closing, make sure no
water remains in the boiler.
7. Replace and tighten up the boiler
drainage plug with a coin.
8. Insert and close the plastic cover by
turning it to the
position.
14
Automatic clean
warning
(model dependent)
Pilot light (11) will ash indicating that
boiler must be rinsed. To do this, follow the
procedure described in the section above.
To reset the “Calc’n’Clean” counter, switch
the steam station off twice, keeping it off
for at least 30 seconds each time.
(on → 30s off → on → 30s off → on)
* model dependent
Loading ...
Loading ...
Loading ...