Loading ...
Loading ...
Loading ...
15
IMPORTANT INFORMATION ABOUT THE REMOTE AND
BATTERIES
• Discard batteries in a designated disposal area. Do not
throw them into a re.
• Remove old batteries immediately to prevent them from
leaking into the battery compartment.
• If you do not intend to use the remote control for a long time,
then remove the batteries.
• Battery chemicals can cause a rash. If the batteries leak,
clean the battery compartment with a cloth. If chemicals
touch your skin then wash it immediately.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(NiCd, NiMH, etc.) batteries.
• Do not continue using the remote if it gets warm or hot.
• Call our Support Center immediately on the support website.
REMOTE CONTROL RANGE INFORMATION
• The remote control can work at a distance of up to 26 feet in
front of the TV set. (This distance is used by infrared means
in an unpaired state
.
)
• It can work at a 30 degree horizontal or vertical angle. ( This
angle is used by infrared means in an unpaired state.)
PAIRING THE REMOTE CONTROL
1.Pair the remote to the TV after you power it on. Keep the remote
control within 20 feet from the TV. Press and hold the [ ] button
at least 3 seconds to start pairing.
2.If the remote paired successfully then a conrmation will
display on the screen. If it did not pair successfully then an
'unsuccessful' message will display. Repeat step 1.
NOTE:
• If an unknown error occurred with the remote then it could
have been caused by interference. Try to remove what's
causing the interference and pair it again.
• If an unknown error occurred in the remote control while the
battery power is normal, you can take out the batteries and
press any key for 1~2 seconds, then the remote control can
work normally.
• The remote cannot be paired to the TV while the TV is in
standby mode.
1. Press the switch and the battery case
will pop up automatically.
2. Insert two AAA size batteries. Make
sure to match the (+) and ( - ) ends of
the batteries with the (+) and ( - ) ends
indicated in the battery compartment.
3. Push the battery case back to the
remote control.
Loading ...
Loading ...
Loading ...