Loading ...
Loading ...
Loading ...
PICTURE A
PICTURE B
ASSEMBLY INSTRUCTIONS
1. Carefully turn the Main Body upside-down on a scratch-free and stable surface.
Be careful to prevent damage to the cosmetic finish or your floor surfacing.
2. Slide the wheel set fully into the grooves in the base of the heater nearest to the
back of the heater as shown in Picture A.
3. Slide the foot set fully into the grooves at the control panel/power cord end of the
heater as shown in Picture B.
4. Turn the heater the right way up.
Before using this appliance, it must have the castor plates with castors fitted. The
screw pack to attach the feet to your appliance will be taped to either one of the feet
for your appliance, or taped to the plug.
WARNING: Heater must not be used without the feet, castors, wheels
fitted.
This appliance has been supplied with ‘1 way screws’ for permanent installation of the
feet. This is a safety requirement for the New Zealand and Australian market.
Assembly Instructions
WARNING: Operate the appliance in normal upright position only with
wheel assemblies attached to the bottom. Any other position could create a
hazardous situation.
Loading ...
Loading ...
Loading ...