Loading ...
Loading ...
Loading ...
STARTING AND STOPPING
16 – English
Starting and stopping
Cold engine
Ignition: Set the stop switch to the start position. About
one third open. 350BT
350BF
1 Full throttle
2 About one third open.
3 Idle speed
4 Stop switch
It is not allowed to set the stop switch in full throttle
position.
Choke: Set the choke control in the choke position.
Primer bulb: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
Warm engine
Use the same starting procedure as for a cold engine but
without setting the choke control in the choke position.
Starting
Hold the body of the machine on the ground using your
left hand (CAUTION! Not with your foot!). Grip the starter
handle, slowly pull out the cord with your right hand until
you feel some resistance (the starter pawls grip), now
quickly and powerfully pull the cord.
Never wrap the
starter cord around your hand
Repeat pulling the cord until the engine starts. When the
engine starts, return choke control to run position.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
Air is released as soon as the engine is started, even
when idling. Do not allow anyone to stand close to the
blower or the blower tube.
Set the required engine speed with the throttle control.
Allow the engine to warm for a few minutes.
Stopping
The engine is stopped by moving the stop switch to the
stop position.
!
WARNING! Always move the machine
away from the refueling area and source
before starting. Place the machine on a
flat surface.
Make sure no unauthorised persons are
in the working area, otherwise there is a
risk of serious personal injury. The safety
distance is 15 meters (50 ft.).
The machine may only be started in its
complete design. If the machine is
started without all the guards fitted there
is a risk of personal injuries.
(4)
(3)
(2)
(1)
4
1
3
2
H1158737-49,350BT,BF,USCAUE.fm Page 16 Tuesday, February 21, 2017 10:56 AM
Loading ...
Loading ...
Loading ...