Loading ...
Loading ...
Loading ...
4
The manufacturer does not accept responsibility for any damages that may arise due to non-
observation of these instructions.
• Do not use the unit if it is damaged. If you are in any doubt, consult an engineer.
• Connection and installation of your Husky unit are to be carried out in strict compliance
with the relative instructions in this user manual.
• Make sure there is a suitable power outlet (230 volts, 13 amps outlet) with proper
grounding to power the refrigerator/freezer.
• For safety, the unit must be properly earthed in accordance with specifications.
• Always remember to unplug the unit before cleaning. Never unplug this unit by pulling
on the power cable. Always grip plug firmly and pull straight out from the socket.
• All electrical repairs must be carried out by a qualified engineer. Inadequate repairs may
be dangerous.
• Do not damage any parts of the unit which carry refrigerant by piercing, perforating,
crushing, twisting or scraping. If refrigerant comes into contact with the eyes it may
cause serious eye injury.
• Do not obstruct or cover the ventilation grille.
• Do not allow children to play with the unit, or to sit on it or hang onto the door.
• This unit is not intended for use by persons (including children) with reduced physical,
sensory or mental capabil ities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the unit by a person responsible
for their safety.
BEFORE USING FOR THE FIRST TIME
IMPORTANT: Before switching the unit on, we recommend you allow it to stand
upright for 8 hours. Failure to do this may result in damage to the unit.
• Remove the wooden pallet and the packing.
• To ensure correct operation, it is important
that the unit is level. If the unit is fitted with
legs, these may be adjusted by screwing the
foot up or down (see Fig. 1). Use a spirit
level to check.
• Before operation, the protective film must
be removed. We recommend that the
cabinet is cleaned for reasons of hygiene
and to remove any residue left from
manufacture.
• Before operation, you should also remove
the transport safety bar on the compressor.
Remove the whole bar as shown in Fig. 2.
• Ensure there is sufficient space at the sides
of the unit to clean/replace the shelves, and to clean around the hinge.
• For good circulation, vents must not be blocked. Keep a minimum of 150mm of clear
space around the refrigerator/freezer. Your Husky unit should be placed on flat and firm
surface for quieter operation.
• Do not expose the unit to direct sunlight or a heat source such as ovens, radiators,
heaters, etc.
• Do not under any circumstances place heated food or beverages in your Husky
Fig. 1
Fig. 2
International CGN_FGN manual 010617.indd 4 01/06/2017 12:49
Loading ...
Loading ...
Loading ...