Loading ...
Loading ...
Loading ...
6
Hold the iron a few
centimetres from the
fabric to avoid
burning delicate
fabrics.
Filling the water tank
• Check that the Ultracord system is properly locked.
• Unplug your iron before filling it.
• Set the steam control to “0” – fig.1.
• Take the iron with one hand and tilt it slightly, with the nose of the
soleplate pointing down.
• To open the flap of the water tank, push the button – fig.2.
• Fill the tank up to the “MAX” line – fig.3.
• Close the flap of the water tank, until it clicks into place.
Use
Adjust the temperature and the steam
• Set the thermostat control – fig.4, referring to the table below.
• The thermostat light comes on. It will go out when the soleplate is hot enough – fig.5.
RECOMMENDATIONS
• Your iron heats up quickly: so begin by ironing fabrics that are ironed
at low temperatures first, then go on to those requiring a higher
temperature,
• If you turn down the thermostat, wait until the thermostat light
comes back on before beginning to iron again,
• When ironing fabrics with mixed fibres, set the ironing temperature for
the most delicate fibre. For delicate fabrics we recommend testing the
fabric first on an inconspicious place eg (inside the hem).
Spray Function
• Whether steam or dry ironing, you are able to use the spray button to
dampen laundry to remove stubborn creases – fig.6.
Obtain more steam
• Press the Steam button from time to time – fig.7.
• Wait a few seconds between each shot before pressing the Steam
button again.
Vertical steam ironing
• Hang the garment on a hanger and hold the fabric slightly pulled
straight with one hand.The steam is very hot, so you should always do
this with the garment on a hanger – never iron clothes which someone
is wearing.
• Set the thermostat control to “MAX” – fig.8.
• Press the Steam button repeatedly – fig.7 moving the iron from
top to bottom – fig.9, wait a couple of seconds between each use of
the button.
FABRIC
POSITION OF
THERMOSTAT CURSOR
STEAM SETTING
POSITION
LINEN
COTTON
WOOL
SILK
SYNTHETIC
(Polyester, Acetate,
Acrylic, Nylon)
MAX
•••
••
•
0
Fill the tank up to
the “MAX”.
Never fill the
appliance by
holding it directly
under the tap.
= STEAM ZONE
In order to avoid
water dripping from
the iron onto the
linen:
- Turn off the steam
when ironing silk or
synthetic fabrics.
- Set it at the
minimum position for
wool.
Make sure that
there is water in the
tank before using
this button.
1800110948-AQUASPEED ULTRACORD USA CAN 24/09/07 15:18 Page 6
Loading ...
Loading ...
Loading ...