Loading ...
Loading ...
Loading ...
20
Before you call for service…
Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions
639&0)7,338-2+ -47
%:)8-1)%2(132)=):-);8,)',%687328,)
*3003;-2+4%+)7*-678%2(=391%=2382))(83'%00*36
7)6:-')
Problem Possible Causes What To Do
Zoneline does (63B;7A7@ • Make sure the Zoneline plug is pushed completely
not start B;=9B5532 into the outlet.
(63=<D3?1<?27@;<A • Remove the room cabinet and make sure that the
47?:9F/AA/1632 yellow connector on the end of the power cord is
firmly engaged.
(634B@37@09<D;17?1B7A • Check the house fuse/circuit breaker box and replace
0?3/83?7@A?7==32 the fuse or reset the breaker.
(63B;7A7@D/7A7;54<? • This is normal. The Zoneline will start again after
A631<:=?3@@<?<C3?9</2 it resets.
=?<A31A<?A<?3@3A
%<D3?4/79B?3 • If power failure occurs, set the mode control to STOP.
When power is restored, set the mode control to the
desired setting.
• There is a protective time delay (up to 3 minutes) to
prevent tripping of the compressor overload. For this
reason, the unit may not start normal heating or cooling
for 3 minutes after it is turned back on.
(631B??3;A7;A3??B=A3? • Press the RESET button located on the power cord plug
23C7137@A?7==32 or the box near the plug.
• If the RESET button will not stay engaged, discontinue use
of the Zoneline and contact a qualified service technician.
Zoneline does not cool ;2<<?/7?49<D • Make sure there are no curtains, blinds or furniture
or heat as it should 7@?3@A?71A32 blocking the front of the Zoneline.
$BA2<<?/7?49<D7@ • Make sure the rear grille is not restricted. This can
?3@A?71A32<??317?1B9/A32 cause the unit to cycle off due to the compressor
overload protector.
• Outdoor grille must have a minimum of 65% free area.
Non-GE grilles may be too restrictive for proper
performance. Consult your salesperson for assistance.
(63A3:=1<;A?<9:/F • Turn the control to a lower or higher setting.
;<A03@3A=?<=3?9F NOTE: ,)8)14)6%896)0-1-8)61%=&)0-1-8-2+8,)
8)14)6%896)6%2+)
(63/7?479A3?7@27?AF • Clean the filter at least every 30 days.
See the 4)6%8-2+27869'8-327 section.
(63?<<::/F6/C3 • When the Zoneline is first turned on you need to
033;6<A<?1<92 allow time for the room to cool down or warm up.
$BA2<<?/7?7@ • Set the vent control to the closed position.
3;A3?7;5A63?<<:
Burning odor at the start B@A7@<;A63@B?4/13 • This can cause a “burning” odor at the beginning of
of heating operation <4A6363/A7;5393:3;A the heating operation. This odor should quickly fade.
Loading ...
Loading ...
Loading ...