Loading ...
Loading ...
Loading ...
Engine Oil u Changing Engine Oil, Cleaning Strainer Screen
62
Maintenance
1.
Place your scooter on its center stand on
a firm, level surface.
2.
If the engine is cold, idle the engine for 3
to 5 minutes.
3.
Turn the ignition switch off, stop the
engine and wait for 2 to 3 minutes.
4.
Place a drain pan under the drain bolt.
5.
Remove the oil fill cap/dipstick, drain bolt
and sealing washer to drain the oil.
6.
Remove the oil plug, spring, and oil
strainer screen and let the remaining oil
drain out.
u Discard the oil at an approved
recycling center.
7.
Clean the oil strainer screen.
8.
Check that the oil strainer screen, sealing
rubber and oil plug O-ring are in good
condition.
9.
Install the oil strainer screen, spring and
oil plug and tighten.
Torque: 15 lbf·ft (20 N·m, 2.0 kgf·m).
Oil fill cap/dipstick
Sealing washer
Drain bolt
Oil plug
Oil plug O-ring
Spring
Oil strainer screen
12 NPS50-31GGA6300.book 62 ページ ２０１１年１１月３０日 水曜日 午前１１時３８分
Loading ...
Loading ...
Loading ...