Loading ...
Loading ...
Loading ...
Part names and
functions
A
B
C
D
E
Infrared sensor
LED indicator
MH
IGHN/MLOWN
Used to change the sensor
sensitivity (page 15).
Rear cover
M N
U
sed to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
Y
ou can press M
N
and check the
LED indicator to confirm the sensor’s
status.
Indicator Status
Green, lit No motion detected
Red, lit Motion was detected
Indicator Status
Red,
b
linking
Sensor is out of range
of the hub
Green,
b
linking
Registration mode
(You pressed and held
M N)
Off No battery power
Note:
R T
he LED indicator does not indicate
sensor status if the sensor has not
been registered (page 8).
Setup overview
1 Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2 Insert the batteries
The motion sensor is battery
powered.
3 Registration
Required only if the motion sensor
was purchased separately (i.e.,
not as part of a bundle).
4 Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5 Installation
Install the motion sensor in the
desired location.
7
Setup
HNS102AZ_(en_en)_0325_ver.031.pdf 7 2015/03/25 14:24:03
Loading ...
Loading ...
Loading ...