Dji E305 User Manual

Loading ...

Note the thread depth and the size of the screws. Mount the motors using the

appropriate screws, according to the thread depth of the assembly hole and the

thickness of your motor mounting plate. Using screws that are too long or too large may

damage the motor.

Make sure that there are no open circuits or exposed wires that can cause short circuits.

It is recommended that you solder a power connector onto the power hub.

4. Mounting the Motors

Mount each motor to a frame arm according to the motor dimensions and the size of the assembly

hole.

Makesurethatthesolderisrmlyattachedtothepowerpadsandthatthereisnopossibility

for a short circuit. The power cable is a coaxial power cable. Do not damage the protector

on the red cable to avoid short circuits.

2) Connect the signal cable to your controller. The signal cable’s orange wire is for the control

signal, and the signal cable’s brown wire is for the GND.

3) Connect the motor to the ESC. Test the motor and ensure that the rotation direction of each

motor is correct. If not, switch the position of any two cables connecting the motor to the

ESC to change the rotation direction.

The outer power pads are for the GND cables, and the inner power pads are for the

power cables. The red core of the coaxial power cable is positive, and the shielding

layer of the coaxial power cable is negative. Make sure to solder them correctly. Try to

solderthecablesrmlytothepowerhubattheproperlength(thewiresshouldbejust

long enough to reach the soldering point, face outwards, and should not be bunched

up in front of the soldering point).

Motor

To the controller

ESC cable

Power cable

Power hub

ESC

28.2 mm

40 mm

26 mm

19 mm

16 mm

4×M3 Thread depth 3.8 mm

Loading ...

Dji E305