Loading ...
Loading ...
Loading ...
24
en Cleaning and maintenance
Warning!
– Do not use cleaning agents containing
alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
Notes:
– Clean all parts immediately after use.
This will prevent residues from drying on
and possibly attacking the plastic (e.g.
essential oils in herbs).
– When processing food such as carrots,
plastic parts may become discoloured,
but this can be removed with a few
drops of cooking oil.
In Fig. J you will find a summary of how to
clean the individual parts.
Using cleaning programme
For quick and easy precleaning.
Fit the empty blender jug onto the
appliance.
Fill with 0.25 litres of warm water and
2 drops of washing-up liquid.
Warning!
The specified quantity of 0.25 litres must
not be exceeded.
Fit the lid and press on firmly.
Close the cap and press down to the
stop.
Set the rotary selector to 0. Switch on
the appliance with button.
Press button. The symbol lights
up. The status display LEDs light up one
by one.
The appliance runs through automatic
precleaning including a brief vacuum
application phase at the start of the
programme. The programme ends
automatically.
Switch off the appliance using button.
Disconnect the mains plug.
Remove the blender jug with the lid.
Grip the vacuum seal at one end and
pull it up. Sufficient air has to get inside
the blender jug for the lid to be removed.
Rinse all parts thoroughly and clean
again if necessary.
To make cleaning the blender jug easier,
remove the cover from the handle and
replace once dry.
Clean the base unit.
Removing the blade insert
X Image sequence G
1. Remove the lid. Turn the blender jug
over.
2. Fit the lid onto the blade insert.
3. Rotate the lid anticlockwise and remove.
4. Remove the blade insert.
Removing the vacuum valve
X Image sequence H
The vacuum valve can be removed for
cleaning.
1. Rotate the vacuum valve anticlockwise
and remove.
2. Thoroughly clean the cap, the two
moisture sensors, the valve and the filter
on the valve.
3. Make sure you dry all parts thoroughly.
4. Fit valve as shown. Marking pointing
to . Rotate the valve clockwise to the
stop. Marking pointing to .
Removing the setting rings
X Image sequence I
In order to clean them thoroughly, the
setting rings in the lid of the vacuum
container can be removed.
1. Insert a small screwdriver into one of
the two recesses of the safety ring and
carefully lever out the ring by applying
slight pressure.
2. Remove the safety ring and setting rings as
shown. Thoroughly clean and dry all parts.
3. Insert the setting rings in the order
shown. Insert the safety ring by applying
slight pressure until it clicks into place.
Loading ...
Loading ...
Loading ...