Loading ...
Loading ...
1.Step 1: Pressing key “FLASH” and hold on, power on the controller, the load LEDs will be 50% brightness white
as responding.
2.Step 2: Pressing “FLASH” 3times in 3 seconds ,corresponding to the operation, the LED’s brightness will change
as 25%-10%-back to preset level.
3.Code learning successfully, the receiver only can be controlled by the remote.
4.If not, please re-operate from step 1 to 2.
Clear code operation
Back to factory default, wall-panel can be controlled by any one the same remote control.
1.Step 1: Pressing key “JUMP7” and hold on, power on the controller, the load LEDs will be 50% brightness
white as responding.
2.Step 2: Pressing ““JUMP7” 3times in 3 seconds ,corresponding to the operation, the LED’s brightness will change
as 25%-10%-back to preset level.
3. Code clearing successfully, the LEDs will be back to the status before the power off, and the receiver can be
controlled by any remote control(any one the same remote control can be used to clear the code).
4.If not, please re-operate from step 1 to 2.
TYPICAL APPLICATION