Loading ...
Loading ...
Loading ...
Mounting the Ventilation Grille -
Figure 35, 36
1. Pull out the bottom freezer drawer.
2. Remove the blue protection film from the dust filter
provided and insert the filter into its opening in the toe
kick area as shown in
Figure 35. Engage the filter
at the bottom, press down the button and click into
place.
3. Mount the ventilation grille as shown in Figure 36.
IMPORTANT
Only use the ventilation grille provided with the
appliance. This grille is required for proper operation
of the appliance.
The ventilation opening must not be covered with a
cabinet base.
Failure to use the supplied grille can result in product
failure and will void the warranty.
Figure 35
Figure 36
Mounting the Freezer Drawer
Panels - Figure 34
1. Pull out the upper freezer drawer and screw on the
panel with three screws at left and right hand side
using the screws as shown in Figure 34.
2. Close the drawer and check the position to the sur-
rounding cabinet panels. Align the panel in verti-
cal direction by loosening the screws left and right.
Finally tighten the screws.
Donotovertighten.Donotuseapower
driver.
3. Pull out the lower freezer drawer and fasten the lower
panel in the same way.
4. Finally cover the gap between the drawer and the
panel of both freezer drawers with the strips provided.
Remove the foil from the adhesive surface of the strip
and stick on the top of the appliance drawer making
sure the flexible gasket is fully inserted in the gap.
3.5 x 13 mm screw
Figure 34
17
InStallatIon
Loading ...