Loading ...
Loading ...
Loading ...
6
Burn-Back (Fire in burner tube or
chamber)!
In the event of a burn-back, where the flame
burns back to the jet, immediately turn off
the gas supply at the control valve on the
panel. After ensuring the flame is
extinguished, re-light the appliance in the
normal manner. Should the appliance again
burn back, close the control valve and call a
service technician. Do not use the
appliance again until the service technician
has declared that it is safe to do so.
Gas-pressure regulator!
This appliance requires an operating
pressure of 2,8 kPa at the appliance. A
suitable LPG regulator that complies with
the requirements of SANS 1237 must be
installed.
Important Information for the user!
This appliance may only be installed by a
registered LP Gas installer. All registered
installers are issued with a card carrying
their registration number. Ask to be shown
the card before allowing the installation
work to commence and make a note of the
Installer QCC number. Upon completion of
the installation, the installer is required to
explain the operational details of the
appliance together with the safety
instructions. You will be asked to sign
acceptance of the installation and be
provided with a completion certificate. You
should only sign for acceptance of the
installation when the installation is
completed to your satisfaction.
Note that your invoice is required in the
event that you wish make a guarantee
claim.
Important Information for the installer!
This appliance may only be installed by a
LP gas installer registered with the Liquefied
Petroleum Gas Association of Southern
Africa. The appliance must be installed in
accordance with the requirements of SANS
10087-1 and any fire department
regulations and/or local bylaws applicable
to the area. If in doubt check with the
relevant authority before undertaking the
installation. Upon completion of the
installation you are required to fully explain
and demonstrate to the user the operational
details and safety practices applicable to
the appliance and the installation.
Causes of damage
Hob
Caution!
■ Only use the burners when cookware has been placed on
top. Do not heat up empty pots or pans. The saucepan base
will be damaged.
■ Clear up spills immediately. Use deep pots for dishes with a
lot of liquid. This will prevent the food from boiling over.
■ Do not use roasting dishes if they must be heated using two
burners. This will cause heat accumulation. The appliance
could be damaged.
■ Cooking on gas burners releases extra heat and moisture.
Adjacent units may become damaged over time. For long
cooking times, switch on the cooker hood or ventilate the
room.
■ Observe the manufacturer's instructions when using special
ovenware.Aluminium foil and plastic containers can melt and
stick on hot burners.
■ Place the pot or pan centrally over the burner. This will
optimise transfer of the heat from the burner flame to the pot
or ban base. The handle does not become damaged, and
greater energy savings are guaranteed.
■ Ensure that the gas burners are clean and dry. The burner
cup and ¶burner cap must be positioned exactly.
Oven
Caution!
■ Accessories, foil, greaseproof paper or ovenware on the
cooking compartment floor: do not place accessories on the
cooking compartment floor. Do not cover the cooking
compartment floor with any sort of foil or greaseproof paper.
Do not place ovenware on the cooking compartment floor.
This will cause heat accumulation. The baking and roasting
times will no longer be correct and the enamel will be
damaged.
■ Inserting accessories: depending on the appliance model,
accessories can scratch the door panel when closing the
appliance door. Always insert the accessories into the
cooking compartment as far as they will go.
■ Water in a hot cooking compartment: do not pour water into
the cooking compartment when it is hot. This will cause
steam. The temperature change can cause damage to the
enamel.
■ Moist food: do not store moist food in the cooking
compartment when it is closed for prolonged periods This will
damage the enamel.
■ Fruit juice: when baking particularly juicy fruit pies, do not
pack the baking tray too generously. Fruit juice dripping from
the baking tray leaves stains that cannot be removed. If
possible, use the deeper universal pan.
■ Cooling with the appliance door open: only allow the cooking
compartment to cool when it is closed. Even if the appliance
door is only open a little, front panels of adjacent units could
be damaged over time.
■ Heavily soiled oven seal: if the oven seal is heavily soiled, the
oven door will no longer close properly when the oven is in
operation. The fronts of adjacent units could be damaged.
Always keep the oven seal clean.
■ Oven door as a bearing surface: do not stand or place
objects on the oven door when it is open. Do not hang
objects on the oven door.
■ Carrying the appliance: do not carry or hold the appliance by
the door handle. The door handle cannot support the weight
of the appliance and could break.
Loading ...
Loading ...
Loading ...