Loading ...
Loading ...
Loading ...
30
Sampling Freq. (Digital Audio Output)
[192KHz] – Select this if your A/V Receiver or Amplifier is capable of
handling 192 KHz signals.
[96KHz] – Select this if your A/V Receiver or Amplifier is NOT capable
of handling 192 KHz signals. When this choice is made, this unit
automatically converts any 192 KHz signals to 96 KHz so your system
can decode them.
[48KHz] – Select this if your A/V Receiver or Amplifier is NOT capable
of handling 192 KHz and 96 KHz signal. When this choice is made,
this unit automatically converts any 192 KHz and 96 KHz signals to 48
KHz so your system can decode them.
Check the documentation for your A/V Receiver or Amplifier to verify its
capabilities.
DRC (Dynamic Range Control)
When a disc encoded in Dolby Digital or Dolby Digital Plus is playing back,
you may wish to compress the dynamic range of the audio output (the
difference between the loudest sounds and the quietest ones). This allows
you to listen to a movie at a lower volume without losing clarity of sound.
Set DRC to [On] for this effect.
Note:
The DRC setting can be changed only when a disc is not inserted or the
unit is in complete stop mode.
Speaker Setup
To obtain the best possible sound via the 7.1CH ANALOG AUDIO OUT
connection, set the speaker size and sound level of speakers you have
connected.
[2.1 Channel] – Select this if you connect only the FL, FR and SW
jacks to the amplifier.
[5.1 Channel] – Select this if you connect only the FL, FR, SL, SR, C
and SW jacks to the amplifier.
[7.1 Channel] – Select this if you connect all of the 7.1CH ANALOG
AUDIO OUT jacks to the amplifier.
Select a connection type among [2.1 Channel], [5.1 Channel] and
[7.1 Channel] and press ENTER. The [Speaker Setup] menu appears.
On the [Speaker Setup] menu, you can set each speaker using the
following steps:
1. Use
bb BB
to select a speaker you want to set in the [Speaker] field.
2. Use
vv VV
to select the [SIZE] or [LEVEL] option. And then press
bb BB
to select an appropriate setting.
3. Repeat step 1-2 to set other speakers.
4. Use
vv VV
to select [Test] and press ENTER to emit the test sound
from the selected speaker.
5. Use
vv VV
to select [OK] to complete the speaker setting.
Notes:
• The [Speaker Setup] can be changed only when a disc is not inserted or
the unit is in complete stop mode.
• Because the amplifier is not included on this player for connecting
speakers directly, the sounds are affected by the receiver’s performance.
Thus, the signal level may not be changed correctly when you change
size and level.
BD390-N.BCANLLK-NEW-ENG 8/18/09 5:22 PM Page 30
Loading ...
Loading ...
Loading ...