Loading ...
Loading ...
Loading ...
12
INSTALLATION INSTRUCTIONS
WARNING!
This product is heavy and requires two persons for installation.
Installation work and electrical wiring must be done by qualified person(s)
in accordance with all applicable codes and standards.
IMPORTANT!
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation
1
Preparing for installation:
Before installing your ventilation hood:
Please read the instructions carefully.
Unpack the ventilation hood.
Ensure the voltage (V) and the frequency (Hz) indicated on the serial plate match
the voltage and frequency of the installation site.
Check that the area behind the installation surface to be drilled is clear of any
electrical cables or pipes etc
The ventilation hood surfaces can be damaged during installation if grazed or
knocked by tools. Please take care to protect the surfaces during installation.
Protect the cooktop surface with cardboard, or the like, to prevent damage
occurring whilst the ventilation hood is being installed above.
Temporarily mark the height of the bottom of the ventilation hood and the center
of the cooktop on the wall according to the information given in the ‘Installation
instructions – Height of ventilation hood’ section.
The wall used for mounting the ventilation hood should have sufficient strength
and a flat surface.
2
Attach chimney brackets and ventilation hood mounting screws to the wall
Attach the chimney bracket and upper
chimney bracket (if using the upper chimney)
in the locations shown in Fig.2 (refer to
page13) and Fig.3 (refer to page 14). Use the
1⁄” (30 mm) screws (and expansion plugs if
attaching to masonry).
Attach the upper ventilation hood mounting
screws in the locations shown in Fig.2 (refer to
page 13) and Fig.3 (refer to page 14). Using the
1⁄” (30 mm) screws (and expansion plugs if
attaching to masonry). Ensure that there is a
⁄” (2 mm) gap between the screw head and
the wall (Fig.1).
Fig.1
⁄” (2mm)
Loading ...
Loading ...
Loading ...