Loading ...
Loading ...
Loading ...
subzero.com | 15
Custom Panels
GRILLE PANEL
Remove the bottom grille frame by extracting the two lower
corner screws from each side of the grille assembly. Refer to
the illustration below.
With the bottom section removed, slide the custom grille
panel into the frame. If the panel is thinner than
1
/4" (6), a
ller material will need to be installed to achieve a proper
t. Once the panel is installed, reattach the bottom grille
frame by sliding the corner brackets back into position, then
reinstall the four corner screws.
PANEL INSTALLATION
SIDE PANEL
When installing a custom side panel, an accessory kit is
required and is available through an authorized Sub-Zero
dealer. For local dealer information, visit the nd a show-
room section of our website, subzero.com. Stainless steel
and white enamel side panels are also available from an
authorized Sub-Zero dealer.
IMPORTANT NOTE: The use of side panels may change the
width of the opening.
A custom side panel must be a minimum of 24"
(610) deep
and
1
/2" (13) thick. Routing will be necessary for the side
panel to t ush against the side of the unit. Refer to the
illustrations below.
IMPORTANT NOTE: The height of the side panel will vary
with the height of the grille. Verify the nished height before
modifying the panels.
IMPORTANT NOTE: For over-and-under and French door
models, additional routing will be necessary to accommo-
date the lower hinge plate of the refrigerator.
84"
(2134)
24"
(610)
ROUT TO
3
/16" (5)
(OVER-AND-UNDER
MODELS)
OPTIONAL
TOE KICK
CUT-OUT
4" (102)
20
1
/2"
(521)
5
3
/4"
(146)
1
7
/8"(48)
1" (25)
4
1
/4" (108)
ROUT TO
1
/8" (3)
FRONT
OF SIDE
PANEL
2
5
/8"
(67)
MAIN
FRAME
SIDE PANEL
ROUTING
1" (25)
1
7
/8" (48)
1
/8" (3)
1
/2" (13)
Side panel dimensions
Routing detail
BOTTOM
GRILLE
FRAME
Grille frame assembly
Loading ...
Loading ...
Loading ...