Loading ...
Loading ...
Loading ...
25. Install cable and jam nut to the floating pulley assembly using a 24mm wrench.
Item Description Qty.
1 Cable 1
2 Floating Pulley Assembly 1
3 Nut, M10 Hex Jam 1
Tighten hardware to 20-25 (27.1-33.9 Nm).
NOTE: Thread cable end through the jam nut and into the floating pulley assembly a minimum of 12mm.
Item Description Qty.
1 Cable 1
2 Floating Pulley Assembly 1
3 Nut, M10 Hex Jam 1
Install Seat and Back Pads
1. Install screws and washers securing the seat pad to the main frame using an 8mm Allen wrench.
Item Description Qty.
1 Seat Pad 1
2 Main Frame 1
3 Washer, Flat 3/8" 4
4 Screw, M10 x 1.5, 25mm 4
Tighten hardware to 40-50 in-lb (4.5-5.6 Nm).
Page 21 of 32
Loading ...
Loading ...
Loading ...