Loading ...
Loading ...
Loading ...
Problem Possible cause Solution
The temperature of the shaver is too
high. In this case, the shaver does not
work.
As soon as the temperature of the shaver
has dropped sufciently, you can switch
on the shaver again.
The shaver is not
entirely clean after
I clean it in the
Jet Clean System
(PT927CC/
PT923CC only).
The cleaning uid in the cleaning
chamber is soiled.
Empty and rinse the cleaning chamber
(see chapter ‘Cleaning and maintenance’).
The cleaning uid level is too low.
If the uid volume in the cleaning
chamber drops below the minimum
level during the cleaning program, the
program aborts.The cleaning symbol
and the ‘uid low’ symbol ash at
intervals and the holder returns to its
starting position.
Rell the cleaning chamber with cleaning
uid up to the MAX level (see chapter
‘Cleaning and maintenance’).
You have used another cleaning uid
than the original Philips cleaning uid.
Only use Jet Clean solution HQ200.
You have not closed the locking lever
of the Jet Clean System properly, or
you have not placed the shaver in the
Jet Clean Shaver properly. In these
cases the Jet Clean System starts to
operate, but the cleaning program is
not performed properly.
Place the shaver without protection cap
in the Jet Clean System properly. Close
the locking lever properly.
The Jet
Clean System
(PT927CC/
PT923CC
only) does not
work when I press
the on/off button.
The Jet Clean System is not connected
to the mains.
Put the small plug in the Jet Clean System
and put the adapter in the wall socket.
Water leaks from
the shaver after
cleaning.
This is normal and not dangerous. During rinsing some water may collect
between the power unit and the housing.
After rinsing this water ows out through
the socket. The power unit is completely
watertight so water cannot reach the
electronic parts of the shaver. Your shaver
continues to be absolutely safe.
ENGLISH 21
Loading ...
Loading ...
Loading ...