Loading ...
Loading ...
Loading ...
5
INSTALLATION
INSTRUCTIONS
NOTE: To avoid oor damage, set washer onto cardboard
before moving it.
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
Move washer to within 36" (914 mm) of its nal location. It must
be in a fully upright position.
ELECTRICAL REQUIREMENTS
n
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical
supply is required. A time-delay fuse or circuit breaker is
recommended. It is recommended that a separate circuit
breaker serving only this appliance be provided.
n
This washer is equipped with a power supply cord having
a 3 prong grounding plug.
n
To minimize possible shock hazard, the cord must be plugged
into a mating, 3 prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating outlet
is not available, it is the personal responsibility and obligation
of the customer to have the properly grounded outlet installed
by a qualied electrician.
n
If codes permit and a separate ground wire is used, it is
recommended that a qualied electrician determine that
the ground path is adequate.
n
Do not ground to a gas pipe.
n
Check with a qualied electrician if you are not sure the
washer is properly grounded.
n
Do not have a fuse in the neutral or ground circuit.
Locate all transport bolts on rear of washer (quantity may vary,
depending on model).
1. Move washer
48"
(1.2 m)
2. Locate transport bolts
Loading ...
Loading ...
Loading ...