Loading ...
Loading ...
Loading ...
17
GAS CONNECTION
The connection must be performed by an authorised person according
to the relevant standards.
This appliance is suitable for use with Natural Gas or ULPG.
Before commencing an installation it should be veried that the gas
supply of the appropriate type and pressure is available. If you have to
use your product with a different gas type, you have to apply to authorized
service for the conversion. The connection must be made at the rear of
appliance. Ensure the pipe does not cross the cooker.
The inlet not used must be closed off with the cap and sealing gasket
supplied.
In order to carry on a tightness and sealing safety check ensure that the
knobs on the control panel are closed and the gas cylindir is open.
WARNING: While performing a gas leakage check, never use any kind of
lighter, match, cigarette or similar burning substance.
For the sealing control; ensure that the buttons in the control panel
are closed, but the gas cylinder is open. Apply some soap bubbles to the
connection. If there is gas leakage, there will be foaming in the soaped
area.
WARNING: Test for gas leaks with soapy water solution only.
While inserting the appliance in place ensure that it is on the same level
with the worktop. If required adjust the legs inorder the make level with
the worktop.
Do not make gas hose and electrical cable of your oven go through the
heated areas, especially through the rear side of the oven. Do not move
gas connected oven. Since the forcing shall loosen the hose, gas leakage
may occur.
WARNING: Please use exible hose for gas connection.
WARNING: Use the appliance on a level surface and in a well ventilated
environment.
WARNING: Before placint the appliance, check that the local distribution
conditions (gas type and pressure) conform to the product settings.
Loading ...
Loading ...
Loading ...