Loading ...
Loading ...
Loading ...
10
Pull Unicou
p
le and its hoses com
p
letel
y
out from stora
g
e com
p
artment located at rear of dishwasher
and attach it to the faucet adapter.
Turn water fully on before starting the dishwasher.
3
1
Turn off the water.
Release the water
p
ressure b
y
de
p
ressin
g
the
p
ressure release button. This relieves water
p
ressure and
p
rotects
y
ou, and the
room, from severe splashing.
Release Unicouple from faucet by depressing the collar at the top of the Unicouple connector.
3
2
1
Remove the
p
ower cord
p
lu
g
from the wall rece
p
tacle.
Disconnect Unicouple from faucet adapter.
2
1
If faucet has not threads: attach the faucet ada
p
ter to faucet, then ti
g
hten ever
y
screw
of the adapter. To prevent leaking your should tighten the adapter.
2
Attach the Unicou
p
le connector to the faucet ada
p
ter b
y
de
p
ressin
g
the collar at the to
p
of the connector.
When Unicou
p
le is all the wa
y
u
p
onto the ada
p
ter, release the collar. It will then sna
p
Into
p
osition to
lock the Unicouple in place. The Unicouple s small hose carries water from the faucet to the dishwasher.
Its large hose carries drain water to the sink. Be sure Unicouple is pointing toward the sink bowl drain
opening and the sink drain is open for water that will drain from your dishwasher. If your dishwasher
drains into a disposer, operate the disposer until it is completely empty before starting the dishwasher.
'
Connector of ModelⅠ
A hose that attaches to a sink s
p
ra
y
can burst if it is installed on the same water line as the dishwasher. If
y
our sink has one, it is
recommended thet the hose be disconnected and the hole plugged.
Fused electrical su
pp
l
y
is re
q
uired-co
pp
er wire onl
y
. Time dela
y
fuse or circuit breaker recommended and
p
rovide se
p
arate
circuit serving only this appliance. Outlet should be placed in adjacent cabinet.
Make sure that the plug on the appliance remains accessible after installation.
After making sure that the voltage and the frequency values for the current in the home
correspond to those on the rating plate and that the electrical system is sized for the
maximum voltage on the rating plate, insert the plug into an electrical socket which is
earthed properly. If the electrical socket to which the appliance must be connected is not
appropriate for the , replace the socket ,rather than
using a adaptors or the like as they could cause overheating and burns.
plug (installed by a qualified electrician)
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum
consult our Service Department for advice.
Loading ...
Loading ...
Loading ...