Loading ...
Loading ...
Loading ...
Open the hood.
Remove the electrical connector
from the bulb by squeezing the
connector to unlock the tab, then
slide the connector off the bulb.
Remove the rubber weather seal
by pulling on the tab.If you need to change the high
beam headlight bulb on the left
side, remove the coolant reserve
tank from its holder by pulling it
straight up.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb
socket.
Install the rubber seal over the
back of the headlight assembly.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Insert the socket back into the
headlight assembly. Make sure
the bulb is installed correctly by
looking through the headlight lens.
The pins on the base of the bulb
should fit in the holes in the
headlight assembly. Pivot the hold-
down wire back in place and clip
the end into the slot.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Push the electrical connector onto
the new bulb. Turn on the
headlights to test the new bulb.
(Left side)
Reinstall the radiator reserve tank.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Lights
Maintenance
199
Main Menu
Table of Contents
Loading ...
Loading ...
Loading ...