Loading ...
Loading ...
Loading ...
718579
50
TROUBLESHOOTING AND ERROR TABLE
Problem/
error
Indication on the display unit
and problem description
What to do?
E0 Incorrect settings
Restart the programme. If the error reoccurs, call a
service technician.
E1 Temperature sensor error.
Inlet water too cold. Repeat the washing programme.
If the washing machine reports this error again, call a
service technician.
E2 Door lock error.
Make sure the washing machine door is closed.
Unplug the power cord from the outlet; then, plug
the power cord back into the outlet and switch on
the washing machine.
If the error reoccurs, call a service technician.
E3 Water filling error. Check the following:
• is the water inlet valve open,
• is the filter on the water supply hose clean,
• is the water supply hose deformed (clipped,
clogged etc.),
• is the pressure in the water mains between 0.05
and 0.8 MPa (0,5–8 bar).
Then, press the (3) START/PAUSE button to resume
the programme. If the error reoccurs, call a service
technician.
E6 Water heating error
Restart the programme. If the error reoccurs, call a
service technician.
E7 Water draining error
Check the following:
• is the pump filter clean,
• is the discharge hose clogged,
• is the drain clogged,
• if the discharge hose placed is placed below the
maximum and above the minimum height (see
chapter »INSTALLATION AND CONNECTION/
Connecting and securing the water discharge
hose«);
then, press the (3) START/PAUSE button again. If
the error reoccurs, call a service technician.
E10 Water level sensor error.
Unplug the power cord from the outlet; then, plug
the power cord back into the outlet and switch on
the washing machine.
If the error reoccurs, call a service technician.
718579en.indd 50718579en.indd 50 5. 11. 2020 08:27:545. 11. 2020 08:27:54
Loading ...
Loading ...
Loading ...