Loading ...
Loading ...
Loading ...
en Fault, what to do?
30
Displays flash. Door not closed properly. Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Refill indicator for salt )*
and/or rinse-aid )" is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt
tablets.
Use different special salt.
Refill indicator for salt )*
and/or rinse-aid )" is not
lit.
Refill indicator switched off. Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
There is still enough special salt/
rinse aid available.
Check refill indicator, levels.
Water is left in the
appliance at the end of the
programme.
Filter system or area under the
filters 1R is blocked.
Clean filters and area underneath (see
“Waste water pump”).
Program has not ended yet. Wait until programme ends or reset (see
“Terminating the programme”).
Utensils not dry. No or too little rinse aid in the
dispenser.
Refill rinse aid.
Programme selected without
drying.
Select programme with drying (see
“Overview of programmes”, “Programme
sequence”).
Water collecting in depressions
on the utensils and cutlery.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
The combined detergent used
has a poor drying performance
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Intensive drying to increase
drying not activated.
Activate intensive drying (see “Operating the
appliance”)
Utensils were removed too early
or drying process had not ended
yet.
Wait until program ends or wait until 30 min
after program ends before removing
utensils.
The eco rinse aid used has a poor
drying performance.
Use a proprietary rinse aid. Eco products are
much less effective.
Plastic utensils not dry. Special properties of plastic. Plastic has a lower heat storage capacity
and therefore dries less well.
Fault Cause Remedial action
Loading ...
Loading ...
Loading ...